Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231474 REAR LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 2.REMOVE REAR LIGHT ASSEMBLY

a.

w/o Rear Fog Light:

i.
E337063

Disconnect the 2 connectors.



b.

w/ Rear Fog Light:

i.
E337062

Disconnect the 3 connectors.



c.
E337065

Remove the 3 screws.


d.

Disengage the 3 claws and guide to remove the rear light assembly.