Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243310 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly (w/ TOYOTA Parking Assist-sensor System)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)

PROCEDURE

Hide 81498 1.REMOVE REAR COMBINATION LIGHT COVER LH

Hide 81497 2.REMOVE REAR COMBINATION LIGHT COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B435240C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear bumper assembly as shown in the illustration.


b.
B435241

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



c.
B435242

Remove the 9 clips.


d.
B435243

Remove the 4 screws.


e.
B435244C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 5 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B435246C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws as shown in the illustration.


g.

Disconnect the connector to remove the rear bumper assembly.