Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231482 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E259461E01
1.562,1.954 1.672,2.123 0.110,0.169 10 a

Turn the stop light switch assembly 1/4 clockwise to install it.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of the Plunger
Area Measurement
a 0.6 to 2.6 mm (0.0236 to 0.102 in.)


e.

If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

for LHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD)>ADJUSTMENT


for RHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for RHD)>ADJUSTMENT


NOTICE:

Do not depress or support the brake pedal.



Hide 87211A 2.INSTALL NO. 2 AIR DUCT (for RHD)

Hide 55362C 3.INSTALL PARKING BRAKE MOUNTING BRACKET (for RHD)

Hide 58816C 4.INSTALL FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

Hide 55406B 5.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for RHD)

Hide 58910C 6.INSTALL REAR CONSOLE BOX ASSEMBLY (for RHD)

Hide 73900 7.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY