Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0230367 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for an LHD vehicle.



PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B432316C01
2.052,1.198 2.24,1.198 2.24,1.198 2.438,0.865 true 0.573,2.281 0.948,2.281 true 0.417,2.188 0.729,2.344 0.313,0.156 10 false *a 1.885,1.115 2.198,1.271 0.313,0.156 10 false *b
*a Airbag Connector
*b Airbag Connector Lock


Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the airbag connector lock to install the airbag connector.


e.

Engage the 4 claws and hook to temporarily install the lower No. 1 instrument panel airbag assembly.


f.

Install the lower No. 1 instrument panel airbag assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



Hide 55480D 2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 53601 3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112 5.INSTALL COWL SIDE TRIM BOARD LH

Hide 67914 6.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 55470 7.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Hide 55436A 8.INSTALL INSTRUMENT PANEL FINISH PANEL END LH

Hide 9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION