47121
1.INSTALL BRAKE PEDAL PAD
Install the brake pedal pad from the brake pedal support assembly.
47110
2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Install the nut to the brake pedal support assembly.
|
Nut |
|
Clip |
Temporarily install the brake pedal support assembly with 2 new clips.
Install the 4 nuts.
Tighten the nuts in the order shown in the illustration.
Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.
Engage the clamp to install the wire harness to the brake pedal support assembly.
47264A
3.INSTALL PUSH ROD PIN
|
Lithium soap base glycol grease |
Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
Be sure to install the push rod pin in the correct direction.
47101A
4.INSTALL BRAKE PEDAL RETURN SPRING
|
Front |
Install the brake pedal return spring to the brake pedal support assembly and push rod pin as shown in the illustration.
84345
5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
89510D
6.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY
7.INSTALL STEERING COLUMN ASSEMBLY
8.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Use the same procedure as for LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
9.INSPECT AND ADJUST BRAKE PEDAL