Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for RHD)
RM3210E _54 Brake _047517 BRAKE SYSTEM (OTHER) _0232289 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of brake pedal support assembly
1.

Clear the data stored during previous linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.

2.

Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light/yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)for Initialization
(Click here)for Calibration

CAUTION / NOTICE / HINT

NOTICE:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.


PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

HINT:

Use the same procedure as for LHD.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL


Hide 2.REMOVE STEERING COLUMN ASSEMBLY

Hide 89510D 3.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 84345 4.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 5.REMOVE BRAKE PEDAL RETURN SPRING

a.
C343335

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 47264A 6.REMOVE PUSH ROD PIN

a.
C343336

Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.


Hide 47110 7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C343337

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C343338

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C343355C02
0,0 0,0 false
V100135

Nut
V100136

Clip


Remove the 2 clips.


d.

Remove the 4 nuts and brake pedal support assembly.


e.
C343356

Remove the nut from the brake pedal support assembly.


Hide 47121 8.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.