Home › Engine / Hybrid System › 2ZR-FXE COOLING › COOLING FAN MOTOR
RM3210E _51 Engine / Hybrid System _047499 2ZR-FXE COOLING _0233437 COOLING FAN MOTOR A

2ZR-FXE COOLING  COOLING FAN MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cooling fan motor LH or cooling fan motor RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

·

Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system (Click here)

PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

Hide 16361J 2.REMOVE FAN RH

a.
A375621

Remove the nut and fan RH.


Hide 16361K 3.REMOVE FAN LH

a.
A375622

Remove the nut and fan LH.


Hide 16363F 4.REMOVE COOLING FAN MOTOR RH

a.
A375623

Remove the 3 screws and cooling fan motor RH.


Hide 16363G 5.REMOVE COOLING FAN MOTOR LH

a.
A378098C01
0.094,0.073 0.531,0.438 0.438,0.365 12 false *A 0.094,2.333 0.583,2.625 0.49,0.292 12 false *B
*A Cooling Fan Motor 120 W Type
*B Cooling Fan Motor 160 W Type


Disengage the 3 clamps.


b.
A375626

Remove the 3 screws and cooling fan motor LH.