Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RELAY
RM3210E _58 Vehicle Interior _047513 DOOR LOCK _0236948 DOOR CONTROL RELAY A

DOOR LOCK  DOOR CONTROL RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during windshield wiper relay assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 85970A 2.REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY

a.
B432460

Remove the bolt.


b.

Disengage the guide.


c.

Disconnect the connector to remove the double lock door control relay assembly.