The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly RH removal/installation are shown below.
51201
1.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
48068
2.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Remove the 2 bolts, nut and front lower No. 1 suspension arm sub-assembly RH from the front suspension crossmember sub-assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.