Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU
RM3210E _57 Power Source / Network _047550 NETWORKING _0239149 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during central gateway ECU (network gateway ECU) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of hybrid vehicle control ECU Perform code registration (Immobiliser system)
·

Entry and start system

·

Wireless door lock control system

·

Hybrid control system cannot be started


See Service Bulletin for the registration method.
Clear DTCs (Vehicle proximity notification system)*2 Vehicle proximity notification system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

*2: w/ Vehicle Proximity Notification System

PROCEDURE

Hide 82877 1.REMOVE ECU INTEGRATION BOX RH (for LHD)

Hide 82877 2.REMOVE ECU INTEGRATION BOX LH (for RHD)

Hide 89111 3.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for LHD)

a.

Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).

C348467

NOTICE:
·

If the ECU integration box is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.




Hide 89111 4.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for RHD)

a.

Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).

C348466

NOTICE:
·

If the ECU integration box is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.