Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY
RM3210E _59 Vehicle Exterior _047505 DOOR / HATCH _0240682 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Engage the grommet.


c.

Engage the 4 clamps to install the hood lock control cable assembly.


Hide 53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.


Hide 53601 3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 53510 5.INSTALL HOOD LOCK ASSEMBLY

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly to the hood lock assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.



d.

w/ Engine Hood Courtesy Switch:

i.

Connect the connector.



Hide 53289A 6.INSTALL RADIATOR SUPPORT OPENING COVER

Hide 53876A 7.INSTALL FRONT FENDER LINER LH (for LHD)

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 53875A 8.INSTALL FRONT FENDER LINER RH (for RHD)

Hide 9.INSTALL FRONT WHEEL LH (for LHD)

Hide 10.INSTALL FRONT WHEEL RH (for RHD)

Hide 11.ADJUST HOOD SUB-ASSEMBLY