Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY SYSTEM
RM3210E _58 Vehicle Interior _047509 METER / GAUGE / DISPLAY _0241557 HEADUP DISPLAY SYSTEM T

METER / GAUGE / DISPLAY  HEADUP DISPLAY SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptom are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Headup Display System
Symptom Suspected Area Link
Headup display is not displayed. Fuse (ECU-DCC NO. 2, ECU-IG1 NO. 4) -
Wire harness or connector -
Headup display switch (No. 2 combination switch assembly) circuit Click here
Combination meter mirror ECU Click here
Combination display Click here
Brightness of the headup display does not change. Perform Active Test (Display Brightness) Click here
Read the Data List (Brightness Up Switch (Meter), Brightness Down Switch (Meter)) Click here
Combination meter mirror ECU Click here
Combination display Click here
Combination meter assembly (Meter circuit plate) Click here
Headup display is not displayed in the correct position. Perform Active Test (Display Position) Click here
Read the Data List (Projection Position Up Switch (Meter), Projection Position Down Switch (Meter)) Click here
Combination meter mirror ECU Click here
Combination meter wire Click here
No. 2 combination meter mirror Click here
Combination meter assembly (Meter circuit plate) Click here
Other headup display malfunction (Other systems are normal) Combination meter mirror ECU Click here