The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17430
3.REMOVE TAIL EXHAUST PIPE ASSEMBLY
58390
4.REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY
Remove the 3 bolts.
Disengage the clip to remove the No. 1 floor under cover assembly.
57628C
5.REMOVE REAR FLOOR SIDE MEMBER COVER LH
Remove the 3 bolts and clip (A).
Disengage the clip (B) to remove the rear floor side member cover LH.
77641A
6.REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.
77754B
7.DISCONNECT CHARCOAL CANISTER OUTLET HOSE
Disconnect the charcoal canister outlet hose from the fuel tank filler pipe sub-assembly.
8.DISCONNECT FUEL TANK BREATHER TUBE
Disconnect the fuel tank breather tube from the fuel tank filler pipe sub-assembly.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77213E
9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
46430
10.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts and separate the No. 3 parking brake cable assembly.
77026A
11.DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Slide the clip and disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel pipe.
77209F
12.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77100
13.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77026A
14.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Disengage the 3 clamps to remove the No. 1 fuel evaporation tube sub-assembly from the fuel tank assembly.
77209F
15.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the 3 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77754B
16.REMOVE CHARCOAL CANISTER OUTLET HOSE
Disengage the 2 clamps to remove the charcoal canister outlet hose from the fuel tank assembly.