This DTC is stored when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2343 | Position Initialization Incomplete | Sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized | Sliding roof ECU (Sliding roof drive gear sub-assembly) |
Refer to DTC B2341.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>B2341
If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
The sliding roof system uses the LIN communication system. First, confirm that there are no malfunctions in the LIN communication system. Refer to How to Proceed with Troubleshooting.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.
Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
Sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the sliding roof auto operation.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>OPERATION CHECK
Auto operation operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
DTC B2343 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG