The main body ECU (multiplex network body ECU) receives remote control signals from the driver door key cylinder or electrical key transmitter sub-assembly.* Then, the main body ECU (multiplex network body ECU) activates the power window motor and sends the remote control signals to the sliding roof ECU (sliding roof drive gear sub-assembly) via LIN communication. The sliding roof ECU (sliding roof drive gear sub-assembly) receives those signals and activates the sliding roof motor.
*: w/o Canister Pump Module
The sliding roof key-linked function and sliding roof wireless transmitter-linked function* can be customized. Make sure that the customize settings of both functions are set to ON.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>CUSTOMIZE PARAMETERS
*: w/o Canister Pump Module
If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If a sliding roof ECU (sliding roof drive gear sub-assembly) DTC is output, first perform troubleshooting for the sliding roof ECU (sliding roof drive gear sub-assembly) DTC.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR
Before replacing the main body ECU (multiplex network body ECU) refer to Service Bulletin.
Check the key-linked and wireless transmitter-linked* functions.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>OPERATION CHECK
*: w/o Canister Pump Module
| Result | Proceed to |
|---|---|
| Both the power windows and sliding roof operate by the key-linked and wireless transmitter-linked* functions. | A |
| The sliding roof does not operate by the key-linked or wireless transmitter-linked* function, but all of the power windows operate. | B |
| Both the power windows and sliding roof do not operate by the key-linked or wireless transmitter-linked* function. | C |
*: w/o Canister Pump Module
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check the sliding roof operation.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>OPERATION CHECK
Sliding roof operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the sliding roof ECU (sliding roof drive gear sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Initialize the sliding roof ECU (sliding roof drive gear sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check the key-linked and wireless transmitter-linked* functions.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>OPERATION CHECK
The key-linked and wireless transmitter-linked* functions operate normally.
*: w/o Canister Pump Module
| Proceed to |
|---|
| OK |
| NG |
OK
NG