Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM3210E _55 Steering _047547 POWER ASSIST SYSTEMS _0242387 POWER STEERING SYSTEM G

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK STEERING EFFORT (TORQUE)

NOTICE:

These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


a.

Stop the vehicle on a level, paved surface and align the wheels straight ahead.


b.

c.

Connect the cable to the negative (-) auxiliary battery terminal.


d.

Using a torque wrench, check that the steering wheel set nut is properly tightened.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


e.

Turn the power switch on (READY) so that the power steering is ready to operate.


f.

Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.

Standard Steering Effort (Reference):

5.5 N*m (56 kgf*cm, 49 in.*lbf) or less



g.

Align the front wheels facing straight ahead.


h.

Turn the power switch off.


i.

Disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



j.