Home › Vehicle Exterior › HORN › HORN
RM3210E _59 Vehicle Exterior _047540 HORN _0243307 HORN A

HORN  HORN  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during horn removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle (w/ Intuitive Parking Assist System)

·

Ultrasonic sensor detection angle registration (w/ Intuitive Parking Assist System)


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization Grille Shutter system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 86510 2.REMOVE HIGH PITCHED HORN ASSEMBLY

a.
E338526

Disconnect the connector.


b.

Remove the bolt and high pitched horn assembly.


Hide 86520 3.REMOVE LOW PITCHED HORN ASSEMBLY

a.
E338527

Disconnect the connector.


b.

Remove the bolt and low pitched horn assembly.