Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL(for RHD)
RM3210E _54 Brake _047522 PARKING BRAKE _0243349 PARKING BRAKE PEDAL(for RHD) A

PARKING BRAKE  PARKING BRAKE PEDAL(for RHD)  INSTALLATION  


PROCEDURE

Hide 46250 1.INSTALL PARKING BRAKE PEDAL ASSEMBLY

a.

Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.


b.
C345638

Install a new clip to the No. 1 parking brake cable assembly.


c.
C345637

Temporarily install a new No. 1 wire adjusting nut to the No. 1 parking brake cable assembly.

NOTICE:

If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.



d.
C346588

Bend the parking brake pedal assembly claw.


Hide 46250 2.CONNECT PARKING BRAKE PEDAL ASSEMBLY

a.
C345635C02
0,0 0,0 false
V100155

Bracket


Install the parking brake pedal assembly to the vehicle body with the bolt and 2 nuts.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly shown in the illustration.


Torque:
Bolt : 15 N*m (153 kgf*cm, 11 ft.*lbf)
Nut : 15.5 N*m (158 kgf*cm, 11 ft.*lbf)


b.
C345634

Connect the parking brake switch connector.


c.

Engage the 2 clamps.


Hide 46410 3.CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.
C345633

Install the No. 1 parking brake cable assembly with the bolt.

Torque:
15.5 N*m (158 kgf*cm, 11 ft.*lbf)


b.

Install the front floor carpet assembly to its original position.


Hide 4.INSPECT PARKING BRAKE PEDAL TRAVEL

Hide 5.ADJUST PARKING BRAKE PEDAL TRAVEL

Hide 6.INSPECT BRAKE WARNING LIGHT

Hide 87211A 7.INSTALL NO. 2 AIR DUCT

Hide 55362C 8.INSTALL PARKING BRAKE MOUNTING BRACKET

Hide 58817B 9.INSTALL FRONT NO. 2 CONSOLE BOX INSERT

Hide 55406B 10.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 58910C 11.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 55606 12.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY