Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2015.11–2016.08
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243397 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines (w/ Sliding Roof).

The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines (w/o Sliding Roof).

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Microphone signal is lost
·

Telephone microphone assembly

·

Radio and display receiver assembly

·

Harness or connector

·

Map light assembly*



*: w/ Sliding Roof


WIRING DIAGRAM

E245186E12
0.521,1.833 2.656,2.208 2.135,0.375 10 false Map Light Assembly (Telephone Microphone Assembly)*1 0.521,2.417 2.729,2.604 2.208,0.188 10 false Telephone Microphone Assembly*2 5.031,2.031 6.74,2.458 1.708,0.427 10 false Radio and Display Receiver Assembly 2.229,0.625 2.49,0.792 0.26,0.167 10 false O4 2.708,0.625 3,0.771 0.292,0.146 10 false O2 2.25,0.823 2.427,0.969 0.177,0.146 10 false *1 2.719,0.823 2.917,0.969 0.198,0.146 10 false *2 2.229,1.417 2.49,1.583 0.26,0.167 10 false O4 2.708,1.417 3,1.563 0.292,0.146 10 false O2 2.26,1.625 2.438,1.771 0.177,0.146 10 false *1 2.719,1.625 2.917,1.771 0.198,0.146 10 false *2 2.271,0.427 2.479,0.604 0.208,0.177 10 false 14 2.771,0.427 2.906,0.573 0.135,0.146 10 false 3 3.063,2.104 4.344,2.438 1.281,0.333 10 false *1: w/ Sliding Roof 3.063,2.438 4.344,2.771 1.281,0.333 10 false *2: w/o Sliding Roof 2.271,1.219 2.542,1.438 0.271,0.219 10 false 15 2.771,1.219 2.948,1.365 0.177,0.146 10 false 4 5.073,0.625 5.5,0.813 0.427,0.188 10 false SNS2 4.906,0.521 5.042,0.667 0.135,0.146 10 false 6 5.083,1.427 5.531,1.604 0.448,0.177 10 false MIN- 5.031,1.865 5.469,2.094 0.438,0.229 10 false F31 1.677,0.625 2.104,0.802 0.427,0.177 10 false SNS2 1.688,1.417 2.094,1.635 0.406,0.219 10 false MCO- 4.854,1.313 5.073,1.49 0.219,0.177 10 false 19

PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
E289390C26
1.427,0.656 1.802,0.896 0.375,0.24 2.073,2 2.354,2.677 false 0.125,0.115 0.438,0.313 0.313,0.198 10 false *a 1.49,0.677 1.802,0.875 0.313,0.198 10 false F31 2.427,2.625 2.938,2.885 0.51,0.26 10 false MIN-
*a Component with harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F31-19 (MIN-) - Body ground Always Below 1 Ω



Result:
Result Proceed to
OK (w/o Sliding Roof) A
OK (w/ Sliding Roof) B
NG C



A

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)

B

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

C

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)
a.

Disconnect the F31 radio and display receiver assembly connector.


b.

Disconnect the O2 telephone microphone assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F31-6 (SNS2) - O2-3 (SNS2) Always Below 1 Ω
F31-19 (MIN-) - O2-4 (MCO-) Always Below 1 Ω
F31-6 (SNS2) or O2-3 (SNS2) - Body ground Always 10 kΩ or higher
F31-19 (MIN-) or O2-4 (MCO-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT TELEPHONE MICROPHONE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT TELEPHONE MICROPHONE ASSEMBLY
a.

Remove the telephone microphone assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE>REMOVAL


b.
E221776C05
1.375,1.583 1.625,1.229 false 2,1.583 1.792,1.24 false 0.156,0.156 0.469,0.354 0.313,0.198 10 false *a 1.156,1.635 1.667,1.854 0.51,0.219 10 false MCO- 1.854,1.635 2.26,1.833 0.406,0.198 10 false SNS2
*a Component without harness connected
(Telephone Microphone Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (SNS2) - 4 (MCO-) Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE TELEPHONE MICROPHONE ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
a.

Disconnect the F31 radio and display receiver assembly connector.


b.

Disconnect the O4 map light assembly (telephone microphone assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F31-6 (SNS2) - O4-14 (SNS2) Always Below 1 Ω
F31-19 (MIN-) - O4-15 (MCO-) Always Below 1 Ω
F31-6 (SNS2) or O4-14 (SNS2) - Body ground Always 10 kΩ or higher
F31-19 (MIN-) or O4-15 (MCO-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.INSPECT MAP LIGHT ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.INSPECT MAP LIGHT ASSEMBLY
a.

Remove the map light assembly (telephone microphone assembly).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.
E187117C71
1.896,1.375 2.156,1.813 2.156,1.813 2.365,1.813 false 1.781,1.354 1.573,1.76 1.573,1.76 1.323,1.76 false 0.896,1.667 1.354,1.875 0.458,0.208 10 false MCO- 2.417,1.729 2.833,1.927 0.417,0.198 10 false SNS2 0.156,0.156 0.469,0.354 0.313,0.198 10 false *a
*a Component without harness connected
(Map Light Assembly (Telephone Microphone Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
14 (SNS2) - 15 (MCO-) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

6.REPLACE TELEPHONE MICROPHONE ASSEMBLY
6.REPLACE TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE MAP LIGHT ASSEMBLY