Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243410 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64910J 1.REMOVE TONNEAU COVER ASSEMBLY

Hide 58415E 2.REMOVE REAR NO. 1 FLOOR BOARD

Hide 58432D 3.REMOVE DECK BOARD RETAINER

Hide 64997 4.REMOVE DECK FLOOR BOX LH (w/o Spare Tire)

Hide 64993 5.REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)

Hide 64997 6.REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)

Hide 64995 7.REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)

Hide 64997 8.REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)

Hide 64718D 9.REMOVE DECK TRIM SERVICE HOLE COVER

Hide 58460D 10.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)

Hide 64716D 11.REMOVE REAR DECK TRIM COVER

Hide 71940A 12.REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)

Hide 73350C 13.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 14.REMOVE REAR SEATBACK ASSEMBLY LH

Hide 15.REMOVE REAR SEAT CUSHION ASSEMBLY

Hide 72693 16.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 67918A 17.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332A 18.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 76974F 19.REMOVE REAR UNDER SIDE COVER LH

Hide 71304C 20.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

Hide 62552F 21.REMOVE REAR SEAT SIDE GARNISH LH

Hide 58460D 22.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)

Hide 64937A 23.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (for LH Side)

Hide 64938 24.REMOVE TONNEAU COVER HOOK A (for LH Side)

Hide 81330 25.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Hide 64740C 26.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62480A 27.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

Hide 86011A 28.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E338102

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E221953

Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.


d.
E227453

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.