If the hybrid vehicle control ECU detects a malfunction in its EEPROM, it stores this DTC. If this DTC is stored, replace the hybrid vehicle control ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| P272C46 | Park Pawl Motor Calibration / Parameter Memory Failure | EEPROM malfunction | Hybrid vehicle control ECU | ·
Master Warning Light ·
Does not come on ·
Multi-information Display Error Message ·
Displayed |
DTC stored |
After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereDrivetrain>P610 HYBRID TRANSMISSION / TRANSAXLE>ELECTRONIC SHIFT LEVER SYSTEM>UTILITY
Turn the power switch on (IG).
With the brake pedal depressed, select neutral (N).
Push the P position switch (transmission shift main switch).
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT