These DTCs are stored if the No. 1 headlight ECU sub-assembly LH or No. 1 headlight ECU sub-assembly RH detects an internal malfunction. The No. 1 headlight ECU sub-assembly LH stores DTC B242C or B242D.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B242C | Right Headlight ECU Malfunction | An internal malfunction occurs in the No. 1 headlight ECU sub-assembly RH | No. 1 headlight ECU sub-assembly RH | - |
| B242D | Left Headlight ECU Malfunction | An internal malfunction occurs in the No. 1 headlight ECU sub-assembly LH | No. 1 headlight ECU sub-assembly LH | - |
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch on (IG).
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC B242C and B242D are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (DTC B242C is output) | B |
| NG (DTC B242D is output) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C