Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0244229 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2456  Left Headlight ECU Variation Error  


DESCRIPTION

This DTC is stored when a No. 1 headlight ECU sub-assembly LH which is not compatible with the vehicle has been installed.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2456 Left Headlight ECU Variation Error Incompatible No. 1 headlight ECU sub-assembly LH is installed
·

No. 1 headlight ECU sub-assembly LH

·

ECM


-

CAUTION / NOTICE / HINT

NOTICE:

If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the power switch on (IG).


b.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
OK:

DTC B2456 is not output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK ECM
3.CHECK ECM
a.

Check if the part number of the ECM installed to the vehicle is correct.

OK:

Part number is correct.



Result:
Proceed to
OK
NG



OK

REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH

NG