Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0244352 DRIVING SUPPORT ECU A

CRUISE CONTROL  DRIVING SUPPORT ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during driving support ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 88150A 2.REMOVE DRIVING SUPPORT ECU ASSEMBLY

a.
E336357

Remove the nut.


b.

Disengage the guide.


c.

Disconnect the connector to remove the driving support ECU assembly.

NOTICE:

Do not reuse the driving support ECU assembly if it has been dropped or subjected to a severe impact.