Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT BUZZER
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0244354 DRIVING SUPPORT BUZZER A

CRUISE CONTROL  DRIVING SUPPORT BUZZER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during skid control buzzer removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 86652F 2.REMOVE SKID CONTROL BUZZER

a.
E336353

Disengage the clamp.


b.

Disconnect the connector to remove the skid control buzzer.

NOTICE:

If the skid control buzzer has been struck or dropped, replace it with a new one.