Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0241785 AIR FUEL RATIO SENSOR A

2ZR-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.



a.
A375032C01
1.26,1.563 1.469,1.781 1.469,1.781 1.646,1.781 true 0.906,0.333 1.094,0.5 0.188,0.167 10 true *a 1.635,1.698 1.979,1.875 0.344,0.177 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold (TWC: Front Catalyst).

SST
09224-00011  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




b.

Engage the 2 wire harness clamps.


c.

Connect the air fuel ratio sensor connector.


Hide 55701J 2.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 55736D 3.INSTALL COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735A 4.INSTALL WATER GUARD PLATE LH

Hide 55737B 5.INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

Hide 55738D 6.INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

Hide 7.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 9.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an air fuel ratio sensor.