The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
| Rear wheel alignment adjustment
|
1.
Clear zero point calibration data.
2.
Perform yaw rate and acceleration sensor zero point calibration.
|
·
ABS warning light illuminates
·
Brake warning light / yellow (minor malfunction) illuminates
·
Slip indicator light illuminates
·
VSC disabled or malfunctions
|
( )
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
·
Ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
·
Intelligent clearance sonar system
·
Simple intelligent parking assist system
|
( )
|
| Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )
|
·
Rear height control sensor sub-assembly LH
·
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Initialize No. 1 headlight ECU sub-assembly LH
|
Automatic headlight beam level control system
|
( )
|
| Gas leak from exhaust system is repaired
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )w/ Canister Pump Module
( )w/o Canister Pump Module
|
- CAUTION:
-
-
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.