Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM3210E _53 Suspension _047536 REAR SUSPENSION _0244743 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 57628C 2.REMOVE REAR FLOOR SIDE MEMBER COVER LH

Hide 58390 3.REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY

Hide 48840A 4.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C345067N01
1.885,1.396 2.073,1.604 0.188,0.208 10 true A 1.26,4.271 1.448,4.479 0.188,0.208 10 true B

Loosen the nut (A) of the rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.

Loosen the nut (B) of the rear stabilizer link assembly LH.

NOTICE:

Because the bolt has its own stopper, do not turn the bolt. Loosen the nut with the bolt secured.



c.
C345079C01
1.771,1.51 2.177,1.51 false 1.865,1.854 2.271,1.854 false 2.208,1.427 2.521,1.583 0.313,0.156 10 false *a 2.302,1.771 2.615,1.927 0.313,0.156 10 false *b
*a Wooden Block
*b Jack


Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




d.
C345067

Remove the bolt, 2 nuts and rear stabilizer link assembly LH.


Hide 48830D 5.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 48812 6.REMOVE REAR STABILIZER BAR

a.
C345106

Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings from the rear suspension member sub-assembly.


Hide 48832A 7.REMOVE REAR NO. 1 STABILIZER BAR BRACKET

a.
C348459

Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.


Hide 48818 8.REMOVE REAR STABILIZER BUSHING

a.
C345108

Remove the 2 rear stabilizer bushings from the rear stabilizer bar.