Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SUB RADIATOR
RM3210E _51 Engine / Hybrid System _047524 HYBRID / BATTERY CONTROL _0244770 SUB RADIATOR A

HYBRID / BATTERY CONTROL  SUB RADIATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

·

Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system (Click here)

PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

HINT:

The radiator (for inverter coolant) is part of the radiator (for Engine). If the radiator (for inverter coolant) needs to be replaced, replace the radiator assembly.


a.

Remove the radiator assembly.

Click hereEngine / Hybrid System>2ZR-FXE COOLING>RADIATOR>REMOVAL