Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › ACCELERATOR PEDAL SENSOR
RM3210E _51 Engine / Hybrid System _047524 HYBRID / BATTERY CONTROL _0244772 ACCELERATOR PEDAL SENSOR A

HYBRID / BATTERY CONTROL  ACCELERATOR PEDAL SENSOR  REMOVAL  


PROCEDURE

Hide 67914 1.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 62112 2.REMOVE COWL SIDE TRIM BOARD LH (for LHD)

Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH (for RHD)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 78110K 6.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Type A:

i.
A371741

Disconnect the accelerator pedal sensor assembly connector.


ii.

Remove the 2 nuts and accelerator pedal sensor assembly.

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.




b.

Type B:

i.
A371742

Disconnect the accelerator pedal sensor assembly connector.


ii.

Remove the 3 nuts and accelerator pedal sensor assembly.

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.




Hide 78110K 7.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A375963C02
0.031,0.083 0.292,0.302 0.26,0.219 12 true *A 0.021,2.365 0.281,2.583 0.26,0.219 12 true *B
*A Type A
*B Type B


Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 2 nuts and accelerator pedal sensor assembly.

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.