Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT CLEARANCE SONAR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244854 INTELLIGENT CLEARANCE SONAR SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT CLEARANCE SONAR SYSTEM  C1AF4  Rr Sensor Initialization Incomplete  


DESCRIPTION

When it is judged that the rear sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF4.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF4 Rr Sensor Initialization Incomplete Rear sensor not initialized
·

Initialize rear sensor

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If DTC C1AF4 is output after performing repairs, turn the power switch on (IG) and turn the intelligent clearance sonar system on to clear the DTC.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

·

After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION



PROCEDURE

1.INITIALIZE REAR CORNER ULTRASONIC SENSOR AND REAR CENTER ULTRASONIC SENSOR
a.

Initialize the rear corner ultrasonic sensor and rear center ultrasonic sensor.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>DTC CHECK / CLEAR

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AF4 is output A
DTC C1AF4 is not output B


HINT:

if DTC C1AF4 is still output after initializing the rear corner ultrasonic sensor and rear center ultrasonic sensor 3 times, replace the clearance warning ECU assembly.



A

B

END (REAR SENSORS WERE NOT INITIALIZED)