When ICS detection area adjustment is incomplete, the clearance warning ECU assembly stores DTC C1AF0.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF0 | ICS Detection Area Adjustment Incomplete | ICS detection area adjustment incomplete | ·
Intelligent clearance sonar detection area adjustment ·
Clearance warning ECU assembly |
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
When continuing with the inspection, confirm that the necessary procedures (adjustment, calibration, initialization or registration) have been completed before proceeding.
Perform intelligent clearance sonar system registration.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check for DTCs according to the prompts on the screen.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
If DTC C1AF0 is still output after performing intelligent clearance sonar system registration 3 times, replace the clearance warning ECU assembly.
| Result | Proceed to |
|---|---|
| DTC C1AF0 is output | A |
| DTC C1AF0 is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING