Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244874 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  C1AF5  Fr Side Sensor Initialization Incomplete  


DESCRIPTION

When it is judged that the front side sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF5.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF5 Fr Side Sensor Initialization Incomplete Front side sensor not initialized
·

Initialize front side sensor

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If DTC C1AF5 is output after performing repairs, turn the power switch on (IG) and turn the TOYOTA parking assist-sensor system on to clear the DTC.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR


PROCEDURE

1.INITIALIZE FRONT SIDE ULTRASONIC SENSOR
a.

Initialize the front side ultrasonic sensor LH and RH.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AF5 is output A
DTC C1AF5 is not output B


HINT:

If DTC C1AF5 is still output after initializing the front side ultrasonic sensor LH and RH 3 times, replace the clearance warning ECU assembly.



A

B

END (FRONT SIDE SENSORS WERE NOT INITIALIZED)