Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244874 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  C1AF6  Rr Side Sensor Initialization Incomplete  


DESCRIPTION

When it is judged that the rear side sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF6.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF6 Rr Side Sensor Initialization Incomplete Rear side sensor not initialized
·

Initialize rear side sensor

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If DTC C1AF6 is output after performing repairs, turn the power switch on (IG) and turn the TOYOTA parking assist-sensor system on to clear the DTC.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR


PROCEDURE

1.INITIALIZE REAR SIDE ULTRASONIC SENSOR
a.

Initialize the rear side ultrasonic sensor LH and RH.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AF6 is output A
DTC C1AF6 is not output B


HINT:

if DTC C1AF6 is still output after initializing the rear side ultrasonic sensor LH and RH 3 times, replace the clearance warning ECU assembly.



A

B

END (REAR SIDE SENSORS WERE NOT INITIALIZED)