The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during electrical key and tire pressure warning ECU and receiver removal/installation are shown below.
When replacing the electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
64910J
1.REMOVE TONNEAU COVER ASSEMBLY
58415E
2.REMOVE REAR NO. 1 FLOOR BOARD
58432D
3.REMOVE DECK BOARD RETAINER
64997
4.REMOVE DECK FLOOR BOX LH (w/o Spare Tire)
64993
5.REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)
64997
6.REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)
64995
7.REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)
64997
8.REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)
64718D
9.REMOVE DECK TRIM SERVICE HOLE COVER
58460D
10.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)
64716D
11.REMOVE REAR DECK TRIM COVER
71940A
12.REMOVE REAR SEAT HEADREST ASSEMBLY
73350C
13.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
14.REMOVE REAR SEATBACK ASSEMBLY LH
15.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
16.REMOVE REAR SEAT CUSHION LOCK HOOK
67918A
17.REMOVE REAR DOOR SCUFF PLATE LH
62332A
18.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
76974F
19.REMOVE REAR UNDER SIDE COVER LH
71304C
20.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH
62552F
21.REMOVE REAR SEAT SIDE GARNISH LH
58460D
22.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)
64937A
23.REMOVE NO. 1 TONNEAU COVER HOLDER CAP
64938
24.REMOVE TONNEAU COVER HOOK A
81330
25.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
64740C
26.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
62480A
27.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH
89740A
28.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/o Tire Pressure Warning System)
Do not drop, strike or otherwise subject the smart door control receiver assembly to impact.
If the smart door control receiver assembly is subjected to an impact, replace it with a new one.
Remove the bolt.
Disengage the 2 guides.
Disconnect the connector to remove the smart door control receiver assembly.
897B0
29.REMOVE ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER (w/ Tire Pressure Warning System)
Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.
If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
Remove the bolt.
Disengage the 2 guides.
Disconnect the connector to remove the electrical key and tire pressure warning ECU and receiver.