19500
1.INSTALL IGNITION COIL ASSEMBLY
12261
2.INSTALL VENTILATION HOSE
Install the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.
23250
3.INSTALL FUEL INJECTOR ASSEMBLY
23807V
4.INSTALL NO. 1 DELIVERY PIPE SPACER
23807
5.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
23818
6.INSTALL FUEL VAPOR FEED PIPE
Install the fuel vapor feed pipe to cylinder head cover sub-assembly with the 2 bolts.
17650G
7.INSTALL PURGE VALVE (PURGE VSV)
1628A
8.INSTALL NO. 6 WATER BY-PASS PIPE
Install the No. 6 water by-pass pipe to the cylinder head sub-assembly with the 2 bolts.
Connect the No. 6 water by-pass pipe to the water inlet sub-assembly and slide the clip to secure it.
16289
9.INSTALL NO. 5 WATER BY-PASS PIPE (w/ Exhaust Heat Recirculation System)
Install the No. 5 water by-pass pipe to the cylinder block sub-assembly with the 2 bolts.
Connect the No. 5 water by-pass pipe to the timing chain cover sub-assembly and slide the clip to secure it.
11452
10.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
15301
11.INSTALL ENGINE OIL LEVEL DIPSTICK
17111
12.INSTALL INTAKE MANIFOLD
12261
13.CONNECT VENTILATION HOSE
17141
14.INSTALL EXHAUST MANIFOLD (TWC: Front Catalyst)
17167
15.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
25620
16.TEMPORARILY INSTALL EGR VALVE ASSEMBLY WITH EGR COOLER
Install a new EGR cooler gasket.
Using an E8 "TORX" socket wrench, temporarily install the EGR valve assembly with EGR cooler with the 2 stud bolts.
Temporarily install the bolt and 4 nuts.
25610
17.TEMPORARILY INSTALL EGR PIPE ASSEMBLY
Install new EGR pipe gasket and inlet EGR gasket.
Temporarily install the EGR pipe assembly with the 4 bolts.
25620
18.INSTALL EGR VALVE ASSEMBLY WITH EGR COOLER
|
Bolt |
|
Nut |
Tighten the bolt and 4 nuts.
25610
19.INSTALL EGR PIPE ASSEMBLY
Tighten the bolt and 4 bolts.
16331
20.INSTALL WATER OUTLET (w/ Flow Shutting Valve (Water Valve))
Install the water outlet and a new water outlet gasket to the cylinder head sub-assembly with the 2 nuts.
Connect the No. 9 water by-pass hose to the purge valve and slide the clip to secure it.
Connect the No. 4 water by-pass hose to the EGR valve assembly with EGR cooler and slide the clip to secure it.
Connect the No. 7 water by-pass hose to the No. 2 water by-pass hose and slide the clip to secure it.
16331
21.INSTALL WATER OUTLET (w/o Flow Shutting Valve (Water Valve))
Install the water outlet and new water outlet gasket to the cylinder head sub-assembly with the 2 nuts.
Connect the No. 9 water by-pass hose to the purge valve and slide the clip to secure it.
Connect the No. 4 water by-pass hose to the EGR valve assembly with EGR cooler and slide the clip to secure it.