Home › Drivetrain › P610 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE SYSTEM
RM3210E _52 Drivetrain _047503 P610 HYBRID TRANSMISSION / TRANSAXLE _0244910 HYBRID TRANSAXLE SYSTEM G

P610 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444C 2.REMOVE REAR MOTOR UNDER COVER LH

Hide 3.INSPECT TRANSAXLE FLUID PRESSURE

NOTICE:

Make sure to perform the following inspection after inspecting and adjusting the engine.


a.

Fully apply the parking brake and chock a wheel.


b.

Disconnect No. 1 motor cooling pipe.

i.
C351244

Loosen the flare nut of the No. 1 motor cooling pipe and disconnect the No. 1 motor cooling pipe from the union.


ii.
C350475

Remove the bolt and No. 1 oil cooler tube clamp from the hose bracket.



c.
C343956N01
0.813,1.927 0.813,1.708 false 0.688,1.927 1.031,2.135 0.344,0.208 10 false SST

Install SST to the union.

SST
09993-19015  (09993-00020, 09993-00030)


d.

Put the engine in maintenance mode.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Measure the hybrid transaxle fluid pressure.

Reference:
Maintenance Mode Engine Idle Speed Hybrid Transaxle Fluid Temperature Hybrid Transaxle Fluid Pressure
900 to 1000 rpm 20 to 50°C (68 to 122°F) 10 kPa (0.1 kgf/cm2, 1.5 psi) or more


NOTICE:

Be sure to cancel maintenance mode immediately after the hybrid transaxle fluid pressure check is completed.



f.

Remove SST from the union.


g.

Connect No. 1 motor cooling pipe.

i.

Temporarily connect the No. 1 motor cooling pipe to the union with the flare nut.


ii.

Install the No. 1 oil cooler tube clamp to the hose bracket with the bolt.

Torque:
11.5 N*m (117 kgf*cm, 8 ft.*lbf)


iii.
C343182C01
2.729,1.74 2.927,1.917 0.198,0.177 10 false *a
*a Torque Wrench Fulcrum Length


Using a 17 mm union nut wrench, tighten the flare nut to connect the No. 1 motor cooling pipe.

Torque:
Specified Tightening Torque : 34.3 N*m (350 kgf*cm, 25 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

29.4 N*m (300 kgf*cm, 22 ft.*lbf)





Hide 51444C 4.INSTALL REAR MOTOR UNDER COVER LH

Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER