The hybrid vehicle control ECU monitors its internal operation and detects the following malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P30004B | Hybrid/EV Battery Control System Over Temperature | The HV battery temperature becomes too high due to a malfunction in the HV system.
(1 trip detection logic) |
·
Hybrid vehicle control ECU ·
HV battery |
Does not come on | Master Warning Light:
Comes on |
| DTC No. | Data List |
|---|---|
| P30004B | ·
Hybrid Battery Temperature 1 to 3 ·
Hybrid Battery Cooling Fan Inhaling Air Temperature ·
Ambient Temperature ·
Hybrid Battery Current ·
Hybrid Battery SOC ·
Hybrid Battery Cooling Fan 1 Drive Status ·
Hybrid Battery Cooling Fan |
After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY
Connect the GTS to the DLC3.
Turn the power switch on (IG) and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the power switch off and wait for 2 minutes or more.
Turn the power switch on (IG) and turn the GTS on.
Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Speed", "Hybrid Battery Temperature 1 to 3", "Hybrid Battery Cooling Fan Inhaling Air Temperature", "Ambient Temperature" and "Hybrid Battery Current".
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check for DTCs.
| Proceed to |
|---|
| P30004B only is output. |
| DTCs other than P30004B are also output. |
Turn the power switch off.
P30004B only is output.
DTCs other than P30004B are also output.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT