Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM
RM3210E _59 Vehicle Exterior _047515 WINDOW / GLASS _0245125 WINDOW DEFOGGER SYSTEM J

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  Rear Window Defogger System does not Operate  


DESCRIPTION

When the rear window defogger switch on the air conditioning control assembly is pressed, the operation signal is transmitted to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the DEF relay to operate the window defogger system.

WIRING DIAGRAM

B429612E05
0.844,6.448 3.146,6.646 2.302,0.198 10 false : LIN Communication Line 0.448,1.25 1,1.646 0.552,0.396 10 false Auxiliary Battery 4.385,2.552 6.927,3 2.542,0.448 10 false Back Door Glass (Rear Window Defogger Wire (Upper)) 5.292,6 6.875,6.365 1.583,0.365 10 false Air Conditioning Amplifier Assembly 1.854,5.948 3.958,6.385 2.104,0.438 10 false Air Conditioning Control Assembly (Rear Window Defogger Switch) 0.333,2.073 0.979,2.521 0.646,0.448 10 false IG1-NO. 1 Relay 1.74,1.51 2.177,1.781 0.438,0.271 10 false DEF 1.417,2.229 2.5,2.438 1.083,0.208 10 false ECU-IG1 NO. 3 2.5,1.948 2.938,2.219 0.438,0.271 10 false 1 3.542,1.969 3.979,2.24 0.438,0.271 10 false 2 2.5,1.24 2.938,1.51 0.438,0.271 10 false 5 2.5,0.854 2.938,1.125 0.438,0.271 10 false 4 3.531,1.063 3.969,1.333 0.438,0.271 10 false 3 2.979,2.604 3.417,2.875 0.438,0.271 10 false DEF 4.802,2.052 5.24,2.323 0.438,0.271 10 false 1 6.292,2.042 6.729,2.313 0.438,0.271 10 false 1 6.208,2.25 6.646,2.521 0.438,0.271 10 false R10 4.729,2.25 5.167,2.521 0.438,0.271 10 false R11 6.188,3.219 6.76,3.49 0.573,0.271 10 false R12 6.271,3.021 6.708,3.292 0.438,0.271 10 false 1 4.729,3.208 5.24,3.479 0.51,0.271 10 false R13 4.802,3.01 5.24,3.281 0.438,0.271 10 false 1 5.542,4.427 6.104,4.667 0.563,0.24 10 false RDFG 5.552,5.354 5.99,5.625 0.438,0.271 10 false LIN1 6.063,4.896 6.5,5.167 0.438,0.271 10 false GND 6.469,4.781 6.906,5.052 0.438,0.271 10 false 4 5.354,4.323 5.792,4.594 0.438,0.271 10 false 5 5.281,5.198 5.719,5.469 0.438,0.271 10 false 14 3.188,5.208 3.625,5.479 0.438,0.271 10 false 6 2.802,5.365 3.24,5.635 0.438,0.271 10 false LIN1 1.844,5.792 2.281,6.063 0.438,0.271 10 false F52 5.292,5.844 5.729,6.115 0.438,0.271 10 false F58 4.448,3.521 6.99,3.969 2.542,0.448 10 false Back Door Glass (Rear Window Defogger Wire (Lower))

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the auxiliary battery voltage becomes low, window defogger system operation is canceled to prioritize supplying power to the power steering system.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Check the air conditioning system.

HINT:

Both the window defogger system operation signal and air conditioning system operation signal are transmitted to the air conditioning amplifier assembly via the same communication line.


OK:

The air conditioning system operates normally.



Result:
Proceed to
OK
NG



OK

2.PERFORM ACTIVE TEST USING GTS

NG

2.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Defogger Relay (Rear) Back door glass (Rear window defogger wire) OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Defogger Relay (Rear)
50004 121 22
OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

3.REPLACE AIR CONDITIONING CONTROL ASSEMBLY

NG

4.INSPECT DEF RELAY
3.REPLACE AIR CONDITIONING CONTROL ASSEMBLY
a.

Replace the air conditioning control assembly with a new or known good one.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL>REMOVAL


b.

Check that the window defogger system operates normally.

Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>OPERATION CHECK

OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

END (AIR CONDITIONING CONTROL ASSEMBLY WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

4.INSPECT DEF RELAY

Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (DEF RELAY - IG1 NO. 1 RELAY AND AUXILIARY BATTERY)

NG

REPLACE DEF RELAY

5.CHECK HARNESS AND CONNECTOR (DEF RELAY - IG1 NO. 1 RELAY AND AUXILIARY BATTERY)
a.
B429590C03
0.167,0.146 0.479,0.344 0.313,0.198 10 false *1 1.052,0.271 1.365,0.469 0.313,0.198 10 false *a
*1 No. 2 Engine Room Relay Block and No. 2 Junction Block Assembly
*a DEF Relay Holder


Remove the DEF relay from the No. 2 engine room relay block and No. 2 junction block assembly.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
DEF relay holder terminal-1 - Body ground Power switch on (IG) 11 to 14 V
DEF relay holder terminal-5 - Body ground Power switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.
B429590C03
0.167,0.146 0.479,0.344 0.313,0.198 10 false *1 1.052,0.271 1.365,0.469 0.313,0.198 10 false *a
*1 No. 2 Engine Room Relay Block and No. 2 Junction Block Assembly
*a DEF Relay Holder


Disconnect the F58 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal-2 - F58-5 (RDFG) Always Below 1 Ω
DEF relay holder terminal-2 or F58-5 (RDFG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.
B429629C05
1.531,0.25 1.896,0.49 0.365,0.24 1.281,1.729 1.385,1.083 true 2.417,1.708 2.188,1.177 true 0.104,0.125 0.417,0.323 0.313,0.198 10 false *a 1.594,0.292 1.906,0.49 0.313,0.198 10 false F58 1.156,1.76 1.792,1.99 0.635,0.229 10 false GND 2.271,1.75 2.698,1.958 0.427,0.208 10 false RDFG
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Reconnect the F58 air conditioning amplifier assembly connector.


b.

Reinstall the DEF relay.


c.

Remove the air conditioning amplifier assembly with its connectors still connected.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F58-5 (RDFG) - F58-4 (GND) Power switch on (IG), rear window defogger switch on Below 1 V
F58-5 (RDFG) - F58-4 (GND) Power switch on (IG), rear window defogger switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS (REAR WINDOW DEFOGGER WIRE) - DEF RELAY AND BODY GROUND)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

8.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS (REAR WINDOW DEFOGGER WIRE) - DEF RELAY AND BODY GROUND)
a.
B429590C03
0.167,0.146 0.479,0.344 0.313,0.198 10 false *1 1.052,0.271 1.365,0.469 0.313,0.198 10 false *a
*1 No. 2 Engine Room Relay Block and No. 2 Junction Block Assembly
*a DEF Relay Holder


Disconnect the R10, R11, R12 and R13 back door glass (rear window defogger wire) connectors.


b.

Remove the DEF relay from the No. 2 engine room relay block and No. 2 junction block assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R10-1 - DEF relay holder terminal-3 Always Below 1 Ω
R12-1 - DEF relay holder terminal-3 Always Below 1 Ω
R10-1, R12-1 or DEF relay holder terminal-3 - Body ground Always 10 kΩ or higher
R11-1 - Body ground Always Below 1 Ω
R13-1 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPAIR OR REPLACE BACK DOOR GLASS (REAR WINDOW DEFOGGER WIRE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR