The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning amplifier assembly removal/installation are shown below.
58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
78110K
2.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55406B
4.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
58816C
5.REMOVE FRONT NO. 1 CONSOLE BOX INSERT
88650N
6.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
for LHD:
Remove the screw.
|
Remove in this Direction |
Disengage the guide to remove the air conditioning amplifier assembly as shown in the illustration.
Disconnect each connector.
for RHD:
Remove the screw.
|
Remove in this Direction |
Disengage the guide to remove the air conditioning amplifier assembly as shown in the illustration.
Disconnect each connector.