Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › from 2016.08
RM3210E _56 Audio / Visual / Telematics _057161 TELEMATICS _0287335 TELEMATICS SYSTEM C

TELEMATICS  TELEMATICS SYSTEM  B15C4  SRS Communication Error  


DESCRIPTION

If the telematics transceiver detects an error in communication between itself and the airbag ECU assembly as a result of a self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C4 SRS Communication Error The telematics transceiver detects an error in signals from the airbag ECU assembly when power switch is on (IG).
·

Telematics transceiver

·

Airbag ECU assembly

·

Wire harness or connector

·

Airbag system



WIRING DIAGRAM

E342824E23
1.208,0.833 1.823,1.031 0.615,0.198 10 false GSW3 5.531,0.854 6.146,1.052 0.615,0.198 10 false GSW 1.75,0.729 2.063,0.927 0.313,0.198 10 false 24 5.26,0.729 5.573,0.927 0.313,0.198 10 false 24 0.917,1.406 1.313,1.604 0.396,0.198 10 false F56 5.5,1.417 5.896,1.615 0.396,0.198 10 false F36 0.917,1.583 2.938,1.875 2.021,0.292 10 false Airbag ECU Assembly 5.5,1.583 7.125,1.813 1.625,0.229 10 false Telematics Transceiver

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>REGISTRATION

·

This vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.CHECK DTC (AIRBAG SYSTEM)
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check if airbag system DTCs are output.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR

Body Electrical > SRS Airbag > Trouble Codes
50001 188

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.INSPECT TELEMATICS TRANSCEIVER

B

2.INSPECT TELEMATICS TRANSCEIVER
a.
B240640C14
2.354,1.25 2.563,1.698 2.563,1.698 2.688,1.698 false 0.125,0.125 0.396,0.385 0.271,0.26 10 false *a 2.729,1.625 3.177,1.906 0.448,0.281 10 false GSW 0.208,4.031 0.646,4.292 0.438,0.26 10 false GND
*a Component with harness connected
(Telematics Transceiver)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
24 (GSW) - Body ground Power switch on (IG) 8.0 to 16 V


Reference Waveform:
Item Condition
Tester connection F36-24 (GSW) - Body ground
Tool setting 5.0 V/DIV., 20 ms/DIV.
Vehicle condition Power switch on (IG)



Result:
Proceed to
OK
NG



OK

3.REPLACE TELEMATICS TRANSCEIVER

NG

4.CHECK HARNESS AND CONNECTOR
3.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.CHECK HARNESS AND CONNECTOR
a.

Disconnect the F36 telematics transceiver connector.


b.

Disconnect the F56 airbag ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F36-24 (GSW) - F56-24 (GSW3) Always Below 1 Ω
F36-24 (GSW) or F56-24 (GSW3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR