DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| DIAGNOSIS |
If the skid control ECU detects a malfunction, the ABS and/or brake warning lights come on in accordance with the trouble area, to warn the driver.
w/ Multi-information display:
If the skid control ECU detects a malfunction, the ABS and/or brake warning lights come on and the multi-information display displays warning messages in accordance with the trouble area, to warn the driver.
The table below indicates which lights come on when there are malfunctions in particular functions.
○: Light ON, -: Light OFF


| Item / Trouble Area |
ABS System |
EBD System |
| ABS warning light*1 ABS warning light and warning message*2 |
○ |
○ |
| Brake warning light*1 Brake warning light and warning message*2 |
- |
○ |
- HINT:
- *1: w/o Multi-information display
- *2: w/ Multi-information display
- HINT:
- The DTCs can be read by connecting SST (09843-18040) between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking pattern of the ABS warning light, or by using the intelligent tester (Click here).
- This system has a sensor signal check function (Click here).
- The DTCs can be read by connecting SST (09843-18040) between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking pattern of the ABS warning light, or by using the intelligent tester (Click here).
| CHECK WARNING LIGHT |
Release the parking brake lever.
- CAUTION:
- Before releasing the parking brake lever, set chocks to hold the vehicle for safety.
- HINT:
- When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.
When the ignition switch is turned on (IG), check that the ABS warning light and brake warning light illuminate and then turn off in approximately 3 seconds.

- HINT:
- If the warning lights do not illuminate, confirm whether the bulbs have burned out, and also check for a CAN communication system DTC, since the skid control ECU and combination meter are connected by the CAN communication line.
- If the warning light remains on, perform the relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.
Section Title
See procedure
ABS Warning Light Remains ON
Click here
Brake Warning Light Remains ON
Click here