2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE)
  1. Remove the air cleaner case (Click here).


3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2GR-FE)
  1. Remove the air cleaner case (Click here).


4. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


5. DISCONNECT CONNECTOR

  1. C191855
    Pull the lock lever upward and disconnect the connector.

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.


6. DISCONNECT BRAKE LINE

  1. C191852E01
    Using a union nut wrench (10 mm), disconnect the 6 brake lines from the actuator.

  1. C191854E01
    Place tags or marks to identify the installation locations of each brake line.


7. REMOVE BRAKE ACTUATOR WITH BRACKET

  1. C191856
    Disconnect the brake tube clamp from the bracket.

  1. C191857
    Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.

← REMOVAL (Aug 2007 – Jul 2008)DISASSEMBLY (Nov 2005 – Jul 2008) →