2005-2008 RAV4 · Service Manual CRUISE CONTROL SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

HINT:
  1. Use these procedures to troubleshoot the cruise control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester (with CAN VIM) to check if the CAN communication system is functioning normally.

      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.CHECK INDICATOR LIGHT
      NEXT

      5.CHECK DTC*
      1. Check for DTCs (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).

      4. Result 
        Result
        Proceed to
        DTC does not reoccur
        A
        DTC reoccurs
        B

      B.
      A

      6.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B

      B.
      A

      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECM (Click here)

      2. Data List / Active Test (Click here )

      NEXT

      8.REPAIR OR REPLACE
        NEXT

        9.CONFIRMATION TEST
          NEXT

          10.DIAGNOSTIC TROUBLE CODE CHART
          1. Diagnostic trouble code chart (Click here)

          NEXT

          11.REPAIR OR REPLACE
            NEXT

            12.CONFIRMATION TEST
              NEXT

              ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2007 – Jul 2008)ROAD TEST (Nov 2005 – Jul 2007) →