2005-2008 RAV4 · Service Manual BODY

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, inspect the LIN communication function to ensure there are no malfunctions in the communication system.

    2. ResultĀ 
      Result
      Proceed to
      No DTCs output
      A
      DTCs output
      B

    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      ResultĀ 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        8.RESET POWER WINDOW MOTOR
        1. If the power window master switch AUTO light is blinking, reset the power window motor (Click here).

        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2005)OPERATION CHECK (from Nov 2005) →