Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
6.
INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)
Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Install the driver side knee airbag with the 4 bolts.
Torque:
10 N*m{
101 kgf*cm
, 7 ft.*lbf
}
7.
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
8.
CONNECT POWER STEERING ECU
Connect the 2 steering column connectors to the power steering ECU.
Install the power steering motor wire harness and torque sensor wire harness clamps onto the side of the power steering ECU.
Tilt the steering column up and down to make sure that the power steering motor wire harness and torque sensor wire harness do not interfere with any components.