FAIL-SAFE CHART
System information · Vehicles built from Nov 2005
| POWER WINDOW OPERATION IN FAIL-SAFE MODE |
- HINT:
- If the pulse sensor built into the power window regulator motor (on the driver side) malfunctions, the power window control system enters fail-safe mode.
The power window control system prohibits the following power window operation when the pulse sensor for the jam protection function has problems and the window position or the learned value is abnormal.
Power window control system Power window operation
Ignition switch on (IG)
Key-off
(Within approx. 45 seconds after ignition switch turned off)
Key-off
(After approx. 45 seconds elapsed after ignition switch turned off)
Manual UP
Operation prohibited
Operation prohibited
Operation prohibited
Manual DOWN
Operative
(Jam protection not operative)
Operation prohibited
Operation prohibited
AUTO UP
(hold switch at AUTO UP position)
Operative
(in MANUAL mode)
(Jam protection not operative)
Operation prohibited
Operation prohibited
AUTO UP
Operation prohibited
Operation prohibited
Operation prohibited
AUTO DOWN
Operation prohibited
Operation prohibited
Operation prohibited
- HINT:
- When the pulse sensor is normal, the AUTO UP / DOWN function can be resumed by deactivating fail-safe mode. To deactivate fail-safe mode, pull up the driver door power window switch to the AUTO UP position and hold it for at least 1 second to fully close the window from the fully open position.
If the LIN communication system malfunctions (communication blackout), the power window control system prohibits the following operations.
LIN communication system Power window operation
Ignition switch on (IG)
MANUAL UP
Operative (Jam protection operative)
MANUAL DOWN
Operative (Jam protection not operative)
AUTO UP (hold switch at AUTO UP position)
Operative (Jam protection operative)*
AUTO UP
Operative (Jam protection operative)*
AUTO DOWN
Operative (Jam protection not operative)*
- HINT:
- *: The driver side power window does not operate.