2005-2008 RAV4 · Service Manual ENGINE

B2281 "P" Signal Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

DESCRIPTION

DTC B2281 is output when there is an abnormal circuit between the main body ECU and the shift lock control ECU.
DTC No.
DTC Detection Condition
Trouble Area
B2281
Communication or communication line is abnormal between main body ECU and shift lock control ECU
  1. Main body ECU
  2. Shift lock control ECU
  3. Wire harness or connector

WIRING DIAGRAM

A122229E26

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)

  1. A134279E02
    Disconnect the E18 main body ECU connector.

  1. Disconnect the E44 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E18-15 (P) - E44-7 (P2)
    Below 1 Ω
    E18-15 (P) or E44-7 (P2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK SHIFT LOCK CONTROL ECU
  1. Temporarily replace the shift lock control ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
OK

END (SHIFT LOCK CONTROL ECU IS FAULTY)


← B2278 Engine Switch Circuit Malfunction (from Jan 2007)B2282 Vehicle Speed Signal Malfunction (+ B2283) (from Jan 2007) →