DISCHARGE FUEL SYSTEM PRESSURE procedures must be performed before disconnecting any part of the fuel system.
After performing the DISCHARGE FUEL SYSTEM PRESSURE procedures, pressure will remain in the fuel line. When disconnecting the fuel line, place a cloth or equivalent over fittings to reduce the risk of fuel spray.
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3.
REMOVE FUEL TANK CAP
4.
REMOVE FRONT FLOOR COVER
Remove the nut, bolt, 3 clips and floor cover.
5.
REMOVE NO. 1 FLOOR UNDER COVER
Remove the 2 nuts, clip and floor under cover.
6.
DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts and disconnect the parking brake cable.
7.
REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the 3 clips, 2 bolts and fuel tank protector.
8.
DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Pinch and pull the main tube connector to disconnect the connector from the pipe.
NOTICE:
Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
Do not use any tools to separate the pipe and connector.
Do not forcefully bend or twist the nylon tube.
Check for foreign matter on the pipe seal surface. Clean if necessary.
Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.
Disconnect the EVAP hose from the tank.
9.
DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the filler pipe hose from the fuel tank.
10.
DISCONNECT FUEL TANK BREATHER HOSE
Disconnect the breather hose from the fuel tank.
11.
DISCONNECT FUEL EMISSION HOSE
Remove the fuel air inlet line hose.
12.
REMOVE FUEL TANK FILLER PIPE
Remove the 3 bolts and filler pipe protector.
Remove the 2 bolts and filler pipe.
13.
REMOVE FUEL TANK ASSEMBLY
Set a mission jack underneath the fuel tank.
Remove the 6 bolts and 3 fuel tank bands.
Slightly lower the mission jack.
NOTICE:
Be careful not to cut the wirings.
Fold back approximately half of each cushion rubber so that the wire harness can be detached from the fuel tank in the step below.
Disconnect the fuel pump connector and sender gauge connector.
NOTICE:
Before this procedure, check the connector for dirt, mud or other contamination.
Do not use any tools in this procedure.
Detach the wire harness from the 4 clamps and remove the fuel tank.