DTC Code
|
DTC Detection Condition
|
Trouble Area
|
U0073
|
Any of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, after the output of data from the skid control ECU is completed, the signals cannot be sent for 5 seconds or more.
- The condition that bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession. (Sent signals cannot be received.)
- When the IG1 terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate and deceleration sensor and steering angle sensor continues for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that a delay in receiving data from the yaw rate and deceleration sensor and steering angle sensor occurs more than once within 5 seconds.
|
CAN communication system
|
U0100
|
The IG1 terminal voltage is between 10 and 17.4 V and the vehicle speed is 15 km/h (9 mph) or more, data cannot be received from the ECM for 2 seconds or more.
|
CAN communication system (Skid control ECU to ECM)
|
U0123
|
Either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, data from the yaw rate sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the yaw rate sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to yaw rate and deceleration sensor)
|
U0124
|
Either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, data from the deceleration sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the deceleration sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to yaw rate and deceleration sensor)
|
U0126
|
Either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, data from the steering angle sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.
|
CAN communication system (Skid control ECU to steering angle sensor)
|